Optimization of microwave‐assisted extraction for six inorganic and organic arsenic species in chicken tissues using response surface methodology

Response surface methodology was applied to optimize the parameters for microwave‐assisted extraction of six major inorganic and organic arsenic species (As(III), As(V), dimethyl arsenic acid, monomethyl arsenic acid, p‐arsanilic acid, and roxarsone) from chicken tissues, followed by detection using a high‐performance liquid chromatography with inductively coupled mass spectrometry detection method, which allows the simultaneous analysis of both inorganic and organic arsenic species in the extract in a single run. Effects of extraction medium, solution pH, liquid‐to‐solid ratio, and the temperature and time of microwave‐assisted extraction on the extraction of the targeted arsenic species were studied. The optimum microwave‐assisted extraction conditions were: 100 mg of chicken tissue, extracted by 5 mL of 22% v/v methanol, 90 mmol/L (NH₄)₂HPO₄, and 0.07% v/v trifluoroacetic acid (with pH adjusted to 10.0 by ammonium hydroxide solution), ramping for 10 min to 71°C, and holding for 11 min. The method has good extraction performance for total arsenic in the spiked and nonspiked chicken tissues (104.0 ± 13.8% and 91.6 ± 7.8%, respectively), except for the ones with arsenic contents close to the quantitation limits. Limits of quantitation (S/N = 10) for As(III), As(V), dimethyl arsenic acid, monomethyl arsenic acid, p‐arsanilic acid, and roxarsone in chicken tissues using this method were 0.012, 0.058, 0.039, 0.061, 0.102, and 0.240 mg/kg (dry weight), respectively.     

Column preconcentration and electrothermal atomic absorption spectrometric determination of rhodium in some food and standard samples

In the present work, an electrothermal atomic absorption spectrometric method has been developed for the determination of ultra‐trace amounts of rhodium after adsorption of its 2‐(5‐bromo‐2‐pyridylazo)‐5‐diethylaminophenol/tetraphenylborate ion associated complex at the surface of alumina. Several factors affecting the extraction efficiency such as the pH, type of eluent, sample and eluent flow rates, sorption capacity of alumina and sample volume were investigated and optimized. The relative standard deviation for eight measurements of 0.1 ng/mL of rhodium was ±6.3%. In this method, the detection limit was 0.003 ng/mL in the original solution. The sorption capacity of alumina and the linear range for Rh(III) were evaluated as 0.8 mg/g and 0.015–0.45 ng/mL in the original solution, respectively. The proposed method was successfully applied for the extraction and determination of rhodium content in some food and standard samples with high recovery values.     

Efficient extraction of proteins from recalcitrant plant tissue for subsequent analysis by two‐dimensional gel electrophoresis

Protein extraction for two‐dimensional electrophoresis from tissues of recalcitrant species is quite problematic and challenging due to the low protein content and high abundance of contaminants. Proteomics in Shorea robusta is scarcely conducted due to the lack of a suitable protein preparation procedure. To establish an effective protein extraction protocol suitable for two‐dimensional electrophoresis in Shorea robusta, four procedures (borate buffer/trichloroacetic acid extraction, organic solvent/trichloroacetic acid precipitation, sucrose/Tris/phenol, and organic solvent/phenol/sodium dodecyl sulfate) were evaluated. Following these, proteins were isolated from mature leaves and were analyzed for proteomics, and also for potential contaminants, widely reported to hinder proteomics. The borate buffer/trichloroacetic acid extraction had the lowest protein yield and did not result in any banding even in one‐dimensional electrophoresis. In contrast, organic solvent/phenol/sodium dodecyl sulfate extraction allowed the highest protein yield. Moreover, during proteomics, organic solvent/phenol/sodium dodecyl sulfate extracted protein resolved the maximum number (144) of spots. Further, when proteins were evaluated for contaminants, significant (77–95%) reductions in the nucleic acids, phenol, and sugars were discernible with refinement in extraction procedure. Accumulated data suggested that the organic solvent/phenol/sodium dodecyl sulfate extraction was the most effective protocol for protein isolation for proteomics of Shorea robusta and can be used for plants that have a similar set of contaminants.     

Solid‐phase extraction based on a molecularly imprinted polymer for the selective determination of four benzophenones in tap and river water

This work reports the preparation of molecularly imprinted polymer particles for the selective extraction and determination of four benzophenones from aqueous media. The polymer was prepared by using 4‐vinylpridine as functional monomer, ethylene glycol dimethacrylate as cross‐linker, acetonitrile as porogenic solvent and 2,2’,4,4’‐tetrehydroxybenzophenone as template. Good specific adsorption capacity (Q_max = 27.90 μmol/g) for 2,2’,4,4’‐tetrehydroxybenzophenone was obtained in the sorption experiment and good class selectivity for 2,2’,4,4’‐tetrehydroxybenzophenone, 2,4‐dihydroxybenzophenone, 2,2’‐dihydroxy‐4‐methoxybenzophenone, 2,2’‐dehydroxy‐4,4’‐dimethoxybenzophenone was demonstrated by the chromatographic evaluation experiment. Factors affecting the extraction efficiency of the molecularly imprinted solid‐phase extraction procedure were investigated systematically. An accurate and sensitive analytical method based on the molecularly imprinted solid‐phase extraction coupled with high‐performance liquid chromatography and diode array detection has been successfully developed for the simultaneous determination of four benzophenones from tap water and river water with method detection limits of 0.25–0.72 ng/mL. The recoveries of benzophenones for water samples at two spiking levels (500 and 5000 ng/mL for each benzophenone) were in the range of 86.9–103.3% with relative standard deviations (n = 3) below 9.2%.     

Preparation of novel ionic‐liquid‐modified magnetic nanoparticles by a microwave‐assisted method for sulfonylurea herbicides extraction

Ionic liquids immobilized on magnetic nanoparticles were prepared by an efficient microwave‐assisted synthesis method, and the properties of the ionic liquids were tuned based on the aromatic functional modification of its anion through a simple metathesis reaction. The novel as‐synthesized magnetic materials were characterized by various instrumental techniques. The magnetic nanoparticles have been utilized as adsorbents for the extraction of four sulfonylurea herbicides in tea samples, in combination with high‐performance liquid chromatography analysis. Significant extraction parameters, including type and volume of desorption solvent, extraction time, amount of adsorbent, and ionic strength were investigated. Under the optimum conditions, good linearity was obtained in the concentration range of 1–150 μg/L for metsulfuron‐methyl and bensulfuron‐methyl, and 3–150 μg/L for sulfometuron‐methyl and chlorimuron‐ethyl, with correlation coefficients R² > 0.9987. Low limits of detection were obtained ranging from 0.13 to 0.81 μg/L. The relative standard deviations were 1.8–3.9%. Comparisons of extraction efficiency with conventional solid‐phase extraction equipped with a commercial C₁₈ cartridge were performed. Results indicated that magnetic solid‐phase extraction is simple, time‐saving, efficient and inexpensive with the reusability of adsorbents. The proposed method has been successfully used to determine sulfonylurea herbicides from tea samples with satisfactory recoveries of 80.5–104.2%.     

Development and validation of polymerized high internal phase emulsion monoliths coupled with HPLC and fluorescence detection for the determination of trace tetracycline antibiotics in environmental water samples

A polymerized high internal phase emulsion monolith was used as a novel sorbent for solid‐phase extraction coupled with high‐performance liquid chromatography and fluorescence detection for the determination of oxytetracycline, tetracycline, doxycycline, and chlorotetracycline in environmental water samples. The polymerized high internal phase emulsion monolithic column was prepared by the in situ polymerization of the continuous phase of a high internal phase emulsion containing glycidyl methacrylate, styrene, and divinylbenzene in pipette tips, and then functionalized with iminodiacetic acid. The resulting monolith exhibited highly interconnected porosity and large surface areas, making it an excellent candidate as an solid‐phase extraction sorbent for the enrichment of trace tetracycline antibiotics. Several factors affecting the extraction performance of polymerized high internal phase emulsion monoliths, including the pH of sample solution, the eluting solvents, the sample loading flow rate and volume, were investigated, respectively. Under the optimized conditions, the mean recoveries of oxytetracycline, tetracycline, doxycycline, and chlorotetracycline spiked in pond and farm wastewater samples ranged from 78.1 to 119.3% with relative standard deviation less than 15%. The detection limits (S/N = 3) of the proposed method were in the range of 51–137 pg/mL. This study demonstrated that the monolithic polymerized high internal phase emulsion would be promising solid‐phase extraction sorbents in the extraction and proconcentration of trace analytes from complex samples.     

Preparation of a novel molecularly imprinted polymer for the highly selective extraction of baicalin

The selective extraction of baicalin is important to its quality control especially when the matrices are complicated. In this work, a novel molecularly imprinted polymer was prepared for the selective extraction of baicalin in herbs. The molecularly imprinted polymer was synthesized by the copolymerization of 4‐vinyl pyridine and ethylene glycol dimethacrylate in the presence of baicalin by a precipitation polymerization method. After the optimization of parameters for molecularly imprinted polymer preparation, including the functional monomer, porogen, sampling solvent, and washing solvent, good selectivity was obtained, with an imprinting factor of about 4, which is much better than that achieved by the bulk‐polymerization method. The performances of the prepared molecularly imprinted polymers were systematically investigated, including adsorption kinetics, isotherm experiment, and Scatchard analysis. On the basis of the good adsorptive capability of the prepared molecularly imprinted polymer, it was also applied for the pretreatment of baicalin in Scutellaria baicalensis Georgi. The result showed that most of the matrices were removed and baicalin was selectively enriched.     

Vortex‐assisted liquid–liquid microextraction using a low‐toxicity solvent for the determination of five organophosphorus pesticides in water samples by high‐performance liquid chromatography

Vortex‐assisted liquid–liquid microextraction followed by high‐performance liquid chromatography with UV detection was applied to determine Isocarbophos, Parathion‐methyl, Triazophos, Phoxim and Chlorpyrifos‐methyl in water samples. 1‐Bromobutane was used as the extraction solvent, which has a higher density than water and low toxicity. Centrifugation and disperser solvent were not required in this microextraction procedure. The optimum extraction conditions for 15 mL water sample were: pH of the sample solution, 5; volume of the extraction solvent, 80 μL; vortex time, 2 min; salt addition, 0.5 g. Under the optimum conditions, enrichment factors ranging from 196 to 237 and limits of detection below 0.38 μg/L were obtained for the determination of target pesticides in water. Good linearities (r > 0.9992) were obtained within the range of 1–500 μg/L for all the compounds. The relative standard deviations were in the range of 1.62–2.86% and the recoveries of spiked samples ranged from 89.80 to 104.20%. The whole proposed methodology is simple, rapid, sensitive and environmentally friendly for determining traces of organophosphorus pesticides in the water samples.     

Natural estrogens in dairy products: Determination of free and conjugated forms by ultra high performance liquid chromatography with tandem mass spectrometry

Natural estrogens are synthesized by mammals in different amounts depending on the developmental stage and pregnancy/lactation period, and they may pass into milk, where they are mostly present as glucuronated and sulfated forms. In modern dairy practices, about 75% of milk is produced from pregnant cows; therefore, the amount of hormones that may pass into milk could be of concern. While estrogen determination in milk has been investigated in depth, the individual determination of estrogens and their conjugated forms in dairy products has not been fully addressed. The aim of this work was to develop and assess a sensitive method, using the peculiar retention properties of graphitized carbon black, to extract natural free estrogens and their major conjugated metabolites, without any enzymatic cleavage, from yogurt, cheese, and butter. The free and conjugated estrogens were eluted in two distinct fractions from the solid‐phase extraction cartridge and analyzed separately by ultra high performance liquid chromatography coupled to tandem mass spectrometry. Recoveries were higher than 80% for all the three sample typologies. The highest matrix effects were observed for butter, which was richest in lipid content, but was below 30%. A survey on some commercial dairy products suggests that production processes decreased estrogen content.     

浊点萃取-荧光光度法测定水中的苯酚

基于非离子表面活性剂Triton X-100,以浊点萃取结合荧光光度法测定水中的苯酚,考察影响浊点萃取的各种因素。在pH=3.0的磷酸氢二钠-磷酸二氢钾缓冲溶液中,采用2.0mL Triton X-100(5%)、82℃平衡温度、8min平衡时间的条件下,苯酚被萃取到Triton X-100表面活性剂相与水相分开,用于环境水样中苯酚的测定,结果令人满意。